Updating cabinet hinges victoria is dating changmin of dbsk

This was my first time using the Kreg concealed hinge jig, so I didn’t want to start boring holes in my gorgeous new doors all willy-nilly!I happened to have a scrap of plywood (actually, it was a miscut piece from my outdoor storage bench) that was almost exactly the same size as the smallest door, so I used that to test out my holes.I wanted a minimal amount of space showing between the edge of the box and the edge of the door. Here you can see the difference in the reveal between the 6 mm setting on the right and the 5 mm setting on the left. With the concealed hinge jig set to 6mm, I was ready to drill the holes in my cabinet doors.I’m glad I did a few tests first, because drilling into that beautiful new door was a little nerve-wracking! To keep things simple, I set my hinges four inches from the top and bottom of the door.When I ordered the doors, I wasn’t sure where the hinges would go.Their placement depends on where the shelves are, but the pantry hadn’t been built yet!

updating cabinet hinges-57

Check out the video below to see how easy it is to use the Kreg Concealed Hinge Jig!Kitchen and bathroom remodels are crazy expensive, and most of that cost is the cabinetry.Save a boatload of cash by just updating the doors!Each door was double boxed and carefully wrapped to ensure they arrived in pristine condition.The Artesia doors come in a variety of wood types, but I went with the pre-primed MDF panel with a hardwood frame.

Leave a Reply